Research on Vibration Power Flow of TBM Hydraulic Bend Pipe

ZHANG Huailiang, QU Wei, LI Wei, LIU Sen

Abstract

  The vibration characteristics of the bend pipe were studied by means of vibration power flow, as the problems of transmission efficiency reduction and structure damage for the hydraulic bend pipe of Hard Rock Tunnel Boring Machine (TBM) occur under the environment of strong vibration. Firstly, the calculation model of the elbow vibration power flow was established by the relationship between stress and power. Then, the influence rules of different basic vibration parameters and the elbow structure parameters on the stress were investigated through simulation, and the calculation method of total power and vibration power flow was given. Finally, the structure parameters of pipeline were optimized to reduce the vibration power flow of pipeline by 30.52%, and the design process of bend pipeline was proposed. The results show that the analytical method can provide the theoretical basis for the design and selection of the bend pipe.

 

Keywords: Hard Rock Tunnel Boring Machine (TBM),  vibration power flow,  basic vibration parameters,  structure parameters,  orthogonal test


Full Text:

PDF


References


DU Y L. DU L J. Full face hard rock tunnel boring machine [M]. Wuhan; iluazhong University of Science and Technology Press. 2011. (In Chinese)

GOYDER H G D. WHITE R G. Vibration power flow from machines into built-up structures. Part 1: introduction and approximate analysis of beam and plate-like foundations [J]. Journal of Sound and Vibration. 1980. 68(1): 59 - 75.

GOYDER H G D, WHITE R G. Vibration power flow from machines into built-up structures. Part 11: wave propagation and powerflow in beam-stiffened plates[j_. Journal of Sound and Vibration. 1980. 68(1): 77 - 96.

GOYDER H G D. WHITE R G. Vibration power flow from machines into built-up structures. Part III: power flow through isolation systems[j]. Journal of Sound and Vibration. 1980. 68(1): 97-117.

CUSCHIERI J M. Structural power flow analysis using a mobility approach on L shape plate [J], Acoust Soc AM. 1998. 87(3): 1159- 1165.

VLAHOPOULOS N. ZHAO X. An investigation of power flow in the mid-frequency range for systems of co-linear beams based on a hybrid finite element formulation [J]. Journal of Sound and Vibration. 2001. 212(3) ; 145 - 473.

LI T Y, ZHANG W H. LIU T G. Vibrational power flow analysis of damaged beam structures [J]. Journal of Sound and Vibration. 2001. 212 (1):59-68.

SUN L. LEUNG A Y T. LEE Y Y. et al. Vibration power flower analysis of a MIMO system using the transmission matrix approach [J]. Mechanical System and Signal Processing. 2007. 21(1):365 -388.

WU X J . ZHU S J. A method to calculate the vibration power flow in the feedback vibration control system [J]. Journal of Ship Mechanicals. 2009. 13(2): 298-304. (In Chinese)

J Q. PENG K. et al. A study on the energy flow of diesel engine turbocharged system [J]. Journal of Hunan University (Natural Sciences). 2011.38(5): 48-53. (In Chinese)

YANG J. XIONG Y P. XING J T. Vibration power flow and force transmission behaviour of a nonlinear isolator mounted on a nonlinear base [J]. International Journal of Mechanical Sciences, 2016. 115.238-252.

ZHANG Z T. WU X B. GE Y J, ef al. Wind induced internal resonance and the control method of suspension bridge hangers [J]. Journal of Hunan University (Natural Sciences), 2016. 13(1). 10-19. (In Chinese)


Refbacks

  • There are currently no refbacks.